Home About us Products Models News Honor Network Contact us Substation
location:Home > Vulcanized PulleyNews > How to repair the self aligning ball bearing overheating problem?

Products
More models
Deep Groove Ball Bearing
KA Nylon Retainer Bearing
Deep Groove Ball Bearing
Black Chamfer lmported Process Bearing
35 Class Spherical Roller Bearing
36 Class Spherical Roller Bearing
Lightweight Spherical Roller Bearing
Self-Aligning Ball Bearing
One Way Backstop Bearing
How to repair the self aligning ball bearing overheating problem?
Clicks:82213 Date:1-15
The assembly of 1, our tight coupling belt or bad in a bad state. The belt tension can be adjusted to correct the alignment of the couplings for repair.
2, aligning ball bearing and self axis is too early or too lax instead. When it is too tight, the grinding should be re grinded, and the corresponding shaft should be fitted to the shaft when it is too loose.
3, the condition of the assembly of the motor self aligning ball bearing cover or both sides end cover is not good. The repair method is to tighten the screws on the end cover or self aligning ball bearing cover, and to install and install.
4, also may be self aligning ball bearing lube oil amount is too small, the appearance of impurities or oil ring stuck. This is the case for refueling, changing oil or repairing the oil ring.
5, self aligning ball bearing has been damaged, of course, this situation is rare, and it can be replaced according to the self aligning ball bearings general life.
6, self aligning ball bearing and end cover are tight or loose. Self aligning ball bearing processing room when too tight, too loose in the end cover steel sleeve.
7, self aligning ball bearing lubricating grease too little or too much or iron chips and other impurities. A common knowledge that needs knowledge is self aligning ball bearing. The capacity of lubricating grease should not exceed 70% of the total volume. It can be changed promptly if there is obvious magazine situation.
Previous article: What are the lubrication methods of self aligning ball bearing      Next article: No more
Recommended reading
How to repair the self aligning ball bearing overheating problem? 2018.1.15
Causes and maintenance measures that cause damage to self aligning bal 2017.12.23
Causes and treatment methods for oil leakage of self aligning ball bea 2018.1.4
Recommended products
bearing 6310 C4 for idler
bearing 6310 C4 for idler
bearing 6309 C4 for idler
bearing 6309 C4 for idler
bearing 6308 C4 for idler
bearing 6308 C4 for idler
bearing 6307 C4 for idler
bearing 6307 C4 for idler
 
Corporate Information
Home
Abouts Us
Products
News
Honors
Substation
 
Contacts
+86 635 5638235
Fax:+86 635 5638808
Address:Xu Village Industrial Garden, Gan Town, Guan County, Shandong
 
Follow us
 
Copyright © 2017 Shandong Xinkaite Bearing Co.,Ltd.